Buesing SX-300 N357SX

Summary

On 7 March 1997 at about 18:11 local time, a Buesing SX-300 registered N357SX was involved in an accident near Sitka, Alaska, United States. 2 people were on board and 2 died. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

7 March 1997 at 18:11

Classification

Accident

Location

Sitka, Alaska, United States

Coordinates

56.7292, -134.9993

Aircraft

Buesing SX-300

Registration

N357SX

Category

Airplane

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Ketchikan → Soldotna

Aircraft damage

Destroyed

Weather

VMC

Light

Day

NTSB number

ANC97FA031

2 people died.

the pilot's failure to properly evaluate the presence of icing conditions, and his failure to comply with procedures to use alternate engine air in icing conditions. Factors relating to the accident were: icing (weather) conditions, the pilot's improper application of emergency procedures to maximize available glide distance, and the lack of suitable terrain for a forced landing.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The homebuilt airplane was being operated as an IFR cross-country flight over mountainous/coastal terrain. While cruising at 14,000 ft, about 19 miles from the nearest airport, the pilot encountered a low engine power condition. He declared an emergency, & was given vectors to the airport. The airplane was capable of gliding about 24 miles from 14,000 ft, but was ditched in the ocean, about 5 miles from the airport. The occupants did not egress from the airplane before it sank. The airplane engine had a ram air/alternate air box attached to the fuel control servo which controlled the engine air source. Ram air was unheated & unfiltered, & was to be used when operating in clear/dry air conditions. Alternate air was heated & filtered, & was to be used during an engine emergency, takeoff & landing, when flying in dusty air, or when in conditions where inlet icing could be expected (visual moisture & temperatures of 40 deg F or below). The airplane's air control was found in the ram air position. Weather conditions near the accident site included a temperature & dew point of 35 deg with snow & ice pellets. Upper air conditions along the route of flight included temperatures between -28 to -45 deg C, & humidity levels between 69 & 81 percent. An AIRMET had been issued for the area. It included a caution for light & temporary moderate icing in clouds & in precipitation from 1,000 ft to 12,000 ft. The freezing level was 1,000 ft. The pilot was provided a PIREP that indicated a trace of ice had been encountered in the area.

Quoted verbatim from the NTSB record.