Cessna 172N N738BC

Summary

On 25 December 2001 at about 23:03 local time, a Cessna 172N registered N738BC was involved in an accident near San Clemente, California, United States. 3 people were on board and 2 died, one was seriously injured. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

25 December 2001 at 23:03

Classification

Accident

Location

San Clemente, California, United States

Coordinates

33.3422, -117.5272

Aircraft

Cessna 172N

Registration

N738BC

Category

Airplane

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Carlsbad → Hawthorne

Aircraft damage

Destroyed

Weather

VMC

Light

Day

NTSB number

LAX02FA056

2 people died.

a loss of engine power due to a loss of magneto to engine timing resulting from stress corrosion crack induced fracture, and separation of the magneto impulse coupling spring.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The airplane lost engine power and the pilot ditched it in the Pacific Ocean about 1/4-mile offshore. He was on the return leg of a cross-country flight and had experienced no problems with the airplane or engine on the outbound leg. The pilot did not note any anomalies during the engine run up prior to takeoff on the return leg, and thought that takeoff performance was similar to previous takeoffs with passengers on board. The pilot established the airplane in cruise at 4,500 feet and an airspeed of 90 knots on an airway about 7 miles from the shoreline. He established 2,200 revolutions per minute (rpm) and leaned for cruise. Immediately thereafter, the engine speed dropped to 1,000 rpm. He did not recall any loud noises; he just noted the loss of engine rpm. He attempted to diagnose the problem, but his efforts had no results. The engine stopped, and he made a turn towards the shore. During the glide the pilot was able to affect a restart, but the engine lost power in less than 2 minutes and the rpm never rose above 1,000. The pilot told air traffic control that he wasn't going to make it to shore, and ditched the airplane about 300 yards offshore. The pilot and the passengers exited the airplane before it sank in 70 feet of water. They were on the top of the airplane for about a minute before it sank. Local authorities rescued the pilot and recovered one victim; one victim was not recovered and is presumed to be deceased. Investigators were unable to establish magneto timing or obtain spark during the wreckage examination. Disassembly of the magneto revealed that the impulse coupling spring was fractured and separated at two places. Upon reassembly without the impulse coupling, one magneto fired on all four leads; the other magneto fired intermittently on three leads due to salt water corrosion on the contacts. Metallurgical examination revealed that the surfaces of both coupling spring fractures exhibited micro features of corrosion on the surfaces. These fractured areas appeared consistent with stress corrosion cracking. Optical and scanning electron microscope examinations of the spring pieces uncovered many areas of corrosion and corrosion pitting on the spring surfaces. The corrosion pitting was particularly evident on the edges of the springs, but other corrosion areas were visible on the flat faces of the spring. A broken spring could retard the magneto timing to top dead center or after (the specified timing is 25 degrees before top dead center). The engine logbooks showed that the magneto inspections required in Airworthiness Directive 96-12-07 had been complied with. Examination of the airframe and the rest of the engine found no evidence of an anomaly that would have contributed to a loss of engine power.

Quoted verbatim from the NTSB record.