Piper PA-32R-301T N481CA

Summary

On 1 October 2003 at about 22:41 local time, a Piper PA-32R-301T registered N481CA was involved in an accident near Corona, California, United States. 2 people were on board and 2 died. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

1 October 2003 at 22:41

Classification

Accident

Location

Corona, California, United States

Coordinates

33.9461, -117.5781

Aircraft

Piper PA-32R-301T

Registration

N481CA

Category

Airplane

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Corona → Oakland

Aircraft damage

Destroyed

Weather

VMC

Light

Day

NTSB number

LAX04FA001

2 people died.

failure of the turbocharger exhaust clamp due to a pre-existing weld crack, which allowed the release of high temperature exhaust gasses in the engine compartment, causing an in-flight fire.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

Shortly after takeoff the pilot contacted air traffic controllers and declared an emergency due to an in-flight fire. An airborne witness in another aircraft reported seeing the accident airplane in level flight with black smoke emanating from it. The airborne witness then reported seeing the airplane bank to the left and enter a nose down spiral towards the ground. The airplane impacted flat level terrain in a steep nose down attitude and the post-impact fire consumed the majority of the airplane. The flight was airborne for about 4 minutes before it crashed. The on-scene and detailed post recovery examinations revealed evidence consistent with an in-flight fire in the lower aft engine compartment area in proximity to the turbocharger and the adjacent firewall. Evidence on the nose landing gear strut cylinder suggests that temperatures in this area exceeded the melting point of aluminum while the airplane was in flight. During the engine examination investigators noted that the tension ring of the turbocharger exhaust clamp that retains the exhaust duct to the turbine side of the turbocharger had fractured at the 11 o'clock position. The exhaust clamp bolt remained connected and properly safetied. With this clamp broken and the exhaust ducting loose, hot exhaust gasses would have been directed against the lower firewall. The examination of the turbocharger exhaust clamp showed a high temperature creep/stress rupture that initiated from a crack at one of the resistance welds that joins the sheet metal retainers to the tension ring. The turbocharger gases are approximately 1,200 to 1,500 degrees Fahrenheit, and the tension ring fracture surface showed intergranular brittle fracture across approximately 80-percent of the cross-sectional area initiating at the resistance weld. The heavily oxidized resistance weld region, when compared to the lighter oxidized sheet metal, suggested that the weld crack was pre-existing. A review of past historical Safety Board data revealed three other accidents, FTW98FA325, FTW99LA241, and CHI02FA042, with similar fractures of exhaust clamps, and other referenced data showed that Inconel 718 could crack in an intergranular mode in a time-dependent creep/stress rupture mode in this temperature range. Cockpit/cabin material that showed exposure to fire was found in the wreckage debris field away from any areas affected by the ground fire.

Quoted verbatim from the NTSB record.