Cessna A188B N9747G

Summary

On 16 July 2009 at about 11:40 local time, a Cessna A188B registered N9747G, operated by Nicolet Air LLC, was involved in an accident near Suring, Wisconsin, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

16 July 2009 at 11:40

Classification

Accident

Location

Suring, Wisconsin, United States

Coordinates

44.8842, -88.4581

Aircraft

Cessna A188B

Registration

N9747G

Category

Airplane

Engines

1

Operator

Nicolet Air LLC

Operating rule

Part 137: Agricultural

Purpose of flight

Aerial Application

Phase of flight

Not recorded

Route

Suring → Private Field

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

CEN09LA447

Nobody was injured.

A loss of engine power resulting from the fatigue failure of the crankshaft due to the loss of engine case through-bolt torque. Contributing to the engine failure was the operator's failure to overhaul the engine in accordance with the manufacturer's recommended guidelines.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot reported that the engine began to run very rough during a turn at low altitude. The engine suddenly seized so he made an emergency landing to a wheat field. During the landing, the left main gear collapsed and the left wing and nose of the aircraft dug into the soft soil, sustaining substantial damage. A teardown inspection of the engine revealed fretting wear scars on the crankcase backbone between the number two and three main bearing supports, and the number one, two, and three camshaft journal supports. The number one, two, three, four, and five main crankshaft main bearing supports exhibited fretting wear scars, and the number two and three supports exhibited mechanical damage from bearing shift and rotation. Additionally, the number two intermediate crankshaft main bearings had extruded from their crankshaft positions in the left and right case halves. An unapproved red sealant had been applied to the crankcase backbone. The above signatures are all consistent with an engine crankcase assembly that had lost its through-bolt torque. The crankshaft was fractured through at the number four short cheek between the number two main bearing journal and the number three connecting rod journal. A metallurgical examination of the fracture surface revealed crack arrest marks, which were indicative of a fatigue fracture which emanated from the surface of the number two main bearing journal. The heat treatment of the crankshaft met the manufacturer’s specifications. An examination of the engine logbooks revealed that the engine’s total time was about 1,778 hours and it had about 500 hours since the last major overhaul. The engine’s last overhaul was conducted on September 30, 1986, almost 23 years since the last major overhaul. The engine manufacturer recommends that when the aircraft is used in aerial spraying, the engine be overhauled after an accumulation of 1,200 hours or twelve (12) years, whichever occurs first.

Quoted verbatim from the NTSB record.