Hood John Sidney TANGO N76HT

Summary

On 7 June 2010 at about 17:10 local time, a Hood John Sidney TANGO registered N76HT, operated by Dennis F. Funnemark, was involved in an accident near New Port Richey, Florida, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

7 June 2010 at 17:10

Classification

Accident

Location

New Port Richey, Florida, United States

Coordinates

28.2197, -82.7531

Aircraft

Hood John Sidney TANGO

Registration

N76HT

Category

Airplane

Engines

1

Operator

Dennis F. Funnemark

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Williston → Clearwater

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA10LA301

Nobody was injured.

The improper inspection of the airplane ignition system during the last condition inspection by a mechanic, resulting in an ignition cable disconnecting and a partial loss of engine power.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot descended to 1,000 feet mean sea level and attempted to increase the engine power. The engine did not respond and the pilot realized that the airplane would not be able to make it to the closest airport. He elected to perform a forced landing on a road. An automobile pulled out on the road and the pilot had to extend the airplane's glide. The airplane collided with mangrove trees and came to rest off the side of the road. A postaccident examination of the airframe, flight controls, and engine assembly revealed no evidence of a mechanical malfunction. The airplane was configured with one magneto installed on the left side of the engine and an experimental electronic ignition system installed on the right side. An electronic module was installed on the magneto pad and connected to two high-tension spark coils mounted on top of the engine, which fired the upper spark plugs. There were two wires from the module to each coil supplying the trigger voltage signal to fire the spark plugs. One of the wires to the right coil, firing cylinder Nos. 1 and 3, was not connected. A wiring harness connected the module to the airframe electrical system and the spark coils. The harness was connected to the module with a "D" plug, which was held in place with two screws. The plug was found disconnected from the module and hanging loose. This likely resulted in the complete loss of power to the right ignition system, causing a partial loss of engine power as reported by the pilot. Review of the airplane logbooks revealed the airplane had flown 25.7 hours since the last condition inspection. The airframe and powerplant mechanic who performed that inspection stated that he did not check the "D" plug during that condition inspection.

Quoted verbatim from the NTSB record.