Bell 47D1 N93067

Summary

On 21 January 2014 at about 21:37 local time, a Bell 47D1 registered N93067, operated by Milam Inc, was involved in an accident near Pell City, Alabama, United States. 2 people were on board and 2 had minor injuries. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

21 January 2014 at 21:37

Classification

Accident

Location

Pell City, Alabama, United States

Nearest airport

Grass Covered Clearing (None)

Coordinates

33.5653, -86.3033

Aircraft

Bell 47D1

Registration

N93067

Category

Helicopter

Year built

1965

Engines

1

Operator

Milam Inc

Operating rule

Part 91: General Aviation

Purpose of flight

Business

Phase of flight

Not recorded

Route

Birmingham → Pell City

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA14LA099

2 people had minor injuries.

The pilot’s use of an improper clutch engagement procedure, which resulted in clutch glazing, slippage, and, ultimately, the in-flight disengagement of the clutch and a loss of rotor rpm. Contributing to the accident were the installation of a light-weight clutch assembly and a higher horsepower engine, both of which increased the tendency for clutch slippage, and inadequate inspection of the clutch assembly.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The commercial pilot was completing a business flight in the helicopter. He reported that, while descending the helicopter for a confined off-airport landing, at 25 to 35 ft above ground level, he heard a "snap/pop" and that the engine suddenly began "over-revving." The helicopter started descending and then touched down hard, and one of the main rotor blades struck the helicopter's tail. After touchdown, the engine was still running, but the rotor blades were not moving. Examination of the transmission revealed that it incorporated a light-weight clutch assembly, which was not authorized for use in the installed transmission model. Further examination revealed that the clutch shoe running surface on the inner diameter of the clutch drum exhibited a series of abnormal wear grooves along the entire surface of clutch shoe contact and that the clutch lining of each shoe exhibited glazing, which occurs when the clutch is improperly engaged. The contact surface of each clutch shoe also contained numerous metallic slivers that were atypical of a normal in-service clutch assembly and appeared to be material that had transferred from the drum to the shoes. During the transmission examination, the pilot was asked to describe his normal engine start and clutch engagement procedure. The clutch engagement procedure described by the pilot was not in accordance with the published procedure. The pilot's procedure likely resulted in a lengthy clutch engagement and an extended period of clutch slippage during each start that led to the glazed condition of the clutch assembly. Once the glazed condition began to develop, the period of clutch slippage during each start lengthened, further contributing to the glazed condition. Ultimately, the glazed condition resulted in the in-flight disengagement of the clutch and a loss of rotor rpm. The pilot reported that, about 15 flight hours before the accident, he had a mechanic install an engine in the helicopter that produced 25 more horsepower than the previously installed engine. The installation of the higher horsepower engine would have increased the tendency for slippage of a glazed clutch assembly. The pilot also reported that the transmission had accumulated about 615 hours since overhaul. According to the helicopter's maintenance and overhaul instructions, the transmission should be disassembled every 600 hours to inspect all parts, including the clutch, for damage or excessive wear. Given that the engine had been installed about 15 flight hours before the accident, the 600-hour inspection could have been accomplished at that time. However, review of maintenance records did not indicate that the 600-hour transmission inspection had occurred, and the mechanic who installed the higher horsepower engine reported that he did not disassemble the transmission.

Quoted verbatim from the NTSB record.