Jeffery D Tuttle BDK CARBON CONCEPTS N8008Z

Summary

On 16 September 2016 at about 19:04 local time, a Jeffery D Tuttle BDK CARBON CONCEPTS registered N8008Z was involved in an accident near Wasilla, Alaska, United States. One person was on board and one was seriously injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

16 September 2016 at 19:04

Classification

Accident

Location

Wasilla, Alaska, United States

Coordinates

61.6139, -149.3278

Aircraft

Jeffery D Tuttle BDK CARBON CONCEPTS

Registration

N8008Z

Category

Airplane

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Wasilla → Wasilla

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ANC16LA068

1 person was seriously injured.

The structural failure of both wings’ leading-edge slats, which resulted in a loss of airplane control.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The commercial pilot reported that the accident flight was the first flight in the experimental, amateur-built airplane since he had completed building it. He added that, shortly after departure, while in level cruise flight, he heard a loud "pop" and immediately saw that the left wing's leading-edge slat had buckled and distorted, which made the airplane difficult to control. While maneuvering for an emergency landing, the pilot had to make significant power adjustments to maintain control. After making a right turn to begin the approach to the airport, the right wing's leading-edge slat failed, which resulted in an almost complete loss of airplane control. Subsequently, he guided the airplane to an open road using the rudder and varying the engine power settings. The airplane struck the top of a tree before impacting the road in a nose-low attitude, which resulted in substantial damage to both wings and the fuselage. Each wing was equipped with three carbon fiber leading-edge slats located center, inboard, and outboard. A detailed examination of the airframe and engine revealed that the right wing's leading-edge slats exhibited features consistent with compression failure of the leading edge, trailing edge bond failure, lack of adhesive in the joints, and ply bridging. In addition, the right inboard slat attachment bracket exhibited deformation patterns consistent with an overload failure. The left wing leading edge slats exhibited no leading-edge damage but had signatures consistent with resin starvation. In addition, the left attachment bracket between the inboard and center slats exhibited features consistent with an adhesive failure in the joint and a disbond at the attachment. Microscopic examination of the attachment bracket revealed a lack of adhesion, improper surface preparation, and improper adhesive thickness. No other airframe or engine anomalies were noted.

Quoted verbatim from the NTSB record.