Cessna 560XL N503UP

Summary

On 29 August 2017 at about 02:00 local time, a Cessna 560XL registered N503UP, operated by Wheels Up, was involved in an incident near San Jose, California, United States. 5 people were on board and nobody was injured. The aircraft was slightly damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

29 August 2017 at 02:00

Classification

Incident

Location

San Jose, California, United States

Nearest airport

Norman Y Mineta San Jose Intl (SJC)

Coordinates

37.3619, -121.9267

Aircraft

Cessna 560XL

Registration

N503UP

Category

Airplane

Year built

2003

Engines

2

Operator

Wheels Up

Operating rule

Part 135: Air Taxi & Commuter

Phase of flight

Not recorded

Route

Tucson → San Jose

Aircraft damage

Minor

Weather

VMC

Light

Day

NTSB number

WPR17IA189

Nobody was injured.

The mechanic’s incorrect installation of the right main landing gear (MLG) aft trunnion pivot pin, which resulted in the pin separating from the trunnion, the trunnion puncturing the right wing, and the right MLG collapsing.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot and copilot reported that, during the landing roll, the airplane bounced and then veered right and that the pilot then corrected back to the runway centerline. The copilot added that the airplane’s right side seemed to “dip” as it continued to pull right, and the pilot added that the airplane’s right side was lower than its left side, so they assumed that the right main landing gear (MLG) had a flat tire. Subsequently, the pilot was able to taxi the airplane off the runway and park it on a taxiway, and the passengers disembarked without incident. Examination of the airplane revealed that the aft portion of the right MLG trunnion was protruding through the top of the right wing and that the MLG strut and wheel were positioned out and aft in about a 45° angle from their original position. The right MLG trunnion aft pivot pin was not in the trunnion but remained in the trunnion mount in the aft wing spar; it was easily removed from the mount by hand. The retaining bolt used to keep the pivot pin in the trunnion was in place and secured with a nut and cotter pin. Review of the airplane’s maintenance records revealed that the left and right MLG trunnions had been replaced with new trunnions and trunnion pivot pins 8 days before the incident. The mechanic who performed the work stated that, after installing the right MLG aft trunnion pivot pin, it must have shifted aft when he went to install the bolt through the pin. He stated that an “air-pocket” must have developed and pushed the pin back out. He added that the pin looked fully engaged and that he noted no faults during postmaintenance operational checks. Therefore, based on the evidence, it is likely that, after the mechanic installed the right MLG aft trunnion pivot pin, it backed out, which led to the retaining bolt not being installed in the hole in the pivot pin and resulted in the pin separating from the trunnion, the trunnion puncturing the right wing, and the right MLG collapsing. Following the incident, the airplane manufacturer revised the trunnion pivot pin installation procedures in the Airplane Maintenance Manual. The revision included, in part, a step for maintenance personnel to visually check and ensure that the bolt is visible when looking through the pivot pin from the aft side and that, if it is not visible, to remove it, ensure that the pivot pin is fully installed in the trunnion assembly, and reinstall the bolt.

Quoted verbatim from the NTSB record.