Cirrus SR22T N821SG

Summary

On 13 July 2017 at about 19:45 local time, a Cirrus SR22T registered N821SG was involved in an accident near Schellville, California, United States. 4 people were on board and 2 died, one was seriously injured, one had minor injuries. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

13 July 2017 at 19:45

Classification

Accident

Location

Schellville, California, United States

Nearest airport

Sonoma Skypark (0Q9)

Coordinates

38.2575, -122.4342

Aircraft

Cirrus SR22T

Registration

N821SG

Category

Airplane

Year built

2011

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Sonoma → San Jose

Aircraft damage

Destroyed

Weather

VMC

Light

Day

NTSB number

WPR17FA150

2 people died.

The pilot's failure to maintain adequate airspeed after a loss of engine power, which resulted in an aerodynamic stall at a low altitude from which the pilot was unable to recover. The loss of engine power resulted from the pilot's improper selection for the electric fuel pump setting during climbout, which caused an excessively high fuel flow to the engine. Contributing to the accident was the pilot's failure to follow the airplane manufacturer's emergency procedures for a low-altitude loss of engine power.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The private pilot and three passengers departed on a personal cross-county flight. Several witnesses located at or near the airport reported that, while the  airplane was climbing, they heard the engine "sputter" or "pop" a few times as the airplane flew over their position. Subsequently, they heard a louder sound and, shortly afterward, observed the deployment of the airplane's parachute system. Most of the witnesses observed the airplane descending just before they lost sight of it at tree-top level, which was just before the airplane impacted the ground. A review of the airplane's flight data revealed that, shortly after takeoff, the airplane's engine lost power. At that time, the airplane's airspeed decreased and approached the stall speed; the stall warning system activated twice. From the first stall warning to the end of the data, the airplane's airspeed was between 71 and 75 knots and the airplane was in a bank of about 27°; the airplane's stall speed is 76 knots at a bank angle of 30°. The airplane's parachute system was deployed when the airplane's altitude was about 130 ft mean sea level. When engine power was lost, the pilot failed to maintain an adequate airspeed and did not follow the emergency procedures for a low-altitude engine failure in the Cirrus SR22T Pilot's Operating Handbook (POH), which were to lower the nose, establish an appropriate glide airspeed, and accomplish a landing straight ahead, turning only to avoid obstructions. Postaccident examination of the airframe and engine revealed no anomalies that would have precluded normal operation. However, examination of the top spark plugs in the ignition system revealed that their insulators were dark in color, consistent with a rich fuel/air mixture. The POH stated that the electric fuel pump switch must be set to the "Boost" position for takeoff and climbout. However, the flight data indicated an excessively high fuel flow to the engine that was consistent with the electric fuel pump switch selected to the "High Boost/Prime" position (which is used for priming the fuel pump before engine start) at the time of the loss of engine power. The flight data indicated that the fuel flow increased and peaked at a level that was about 6.5% higher than the average climbout fuel flow just before the power loss. The National Transportation Safety Board's investigation of an accident involving another Cirrus SR22T airplane found that the airplane experienced an engine power loss following that pilot's inadvertent activation of the High Boost/Prime switch, and flight data from that airplane revealed a similar increase in the fuel flow before the loss of engine power. For this accident, both the fuel flow and manifold pressure exceeded the manufacturer's parameters in the POH, peaking about the time of the engine power loss. Further, given that the engine's speed exceeded the manufacturer's upper warning range just before the loss of engine power, the engine components and the fuel system were likely operating effectively before the loss of power. Thus, it is likely that the accident pilot improperly selected the High Boost/Prime position during the climbout, which resulted in the excessive fuel flow to the engine and the subsequent loss of engine power.

Quoted verbatim from the NTSB record.