Cessna A185 N401WC

Summary

On 16 July 2017 at about 01:00 local time, a Cessna A185 registered N401WC was involved in an accident near Wasilla, Alaska, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

16 July 2017 at 01:00

Classification

Accident

Location

Wasilla, Alaska, United States

Coordinates

61.4925, -149.6225

Aircraft

Cessna A185

Registration

N401WC

Category

Airplane

Year built

1973

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Lake Louise → Anchorage

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ANC17LA037

Nobody was injured.

The pilot’s failure to manage fuel quantity in flight, which resulted in a total loss of engine power due to fuel starvation. Contributing to the accident was the pilot’s failure to follow manufacturer guidance for restoring engine power after emptying a fuel tank.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot reported that he departed on a 1.3-hour flight in his floatplane, and about 1 hour into the flight, fuel flow diminished and the engine “sputtered.” He noted that the left tank fuel quantity gauge indicated empty, and the right fuel tank indicated 1/2 full. He verified that the fuel selector was in the “both” position and increased the throttle. The fuel flow increased momentarily, and then the engine lost total power. The pilot performed a forced landing on grassy tidal mud flats, during which one of the floats hit a log and the airplane nosed over, which resulted in substantial damage to the wings, vertical stabilizer, and wing struts. A witness stated that there was no fuel leaking from the wreckage at the scene. An examination of the airframe revealed that only 1.75 gallons of fuel remained in the left tank, which was below the unusable amount of 3 gallons; 8 gallons remained in the right tank. The pilot reported that he departed on the round-trip flight with 62 gallons. The digital fuel flow gauge indicated that 61.2 gallons had been used since refueling and 0.8 gallons of planned fuel remained. The fuel selector and auxiliary fuel pump were functionally tested with no anomalies noted. The vented fuel caps, tank vents, and drain system were intact. A fuel quality sample revealed no contaminants and the drained fuel was used for an engine test run. The engine started and ran at a low power setting with no anomalies observed. According to the pilot, there was sufficient fuel onboard to complete the flight. The engine likely burned fuel primarily from the left tank, for reasons that could not be determined. Had the pilot monitored the fuel quantity indicators or the digital fuel flow quantities during the flight, he would have known that one tank was supplying fuel at a faster rate than the other, that the left tank was approaching empty, and that more fuel than he planned was being consumed. After the loss of power, the pilot responded by "pumping the throttle;" however, manufacturer guidance stated that the pilot should select the fullest tank and turn on the auxiliary fuel pump. Had the pilot followed the manufacturer’s guidance, it is likely that engine power would have been restored.

Quoted verbatim from the NTSB record.