Plane Crash List

Cessna 170 N3962V

13 August 2020 · Ardmore, Tennessee, United States · Minor injuries

Summary

On 13 August 2020 at about 22:45 local time, a Cessna 170 registered N3962V was involved in an accident near Ardmore, Tennessee, United States. 2 people were on board and 2 had minor injuries. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

The record

Date
at 22:45
Classification
Accident
Location
Ardmore, Tennessee, United States
Nearest airport
Pasture (NONE)
Coordinates
35.0436, -86.8286
Aircraft
Cessna 170
Registration
N3962V
Category
Airplane
Year built
1947
Engines
1
Operator
Not recorded
Operating rule
Part 91: General Aviation
Purpose of flight
Personal
Phase of flight
Not recorded
Route
Ardmore → Huntsville
Aircraft damage
Substantial
Weather
VMC
Light
Day
NTSB number
ERA20LA288

People

2 people had minor injuries.

On board Died Serious Minor Uninjured
2 0 0 2 0

Probable cause

The pilot’s inadequate preflight planning and his decision to depart from a constrained, grass-covered field in elevated-density altitude conditions, which resulted in reduced takeoff and climb performance and a subsequent forced landing.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot, a passenger, and a dog were departing from a grass field. The pilot had purchased the airplane about 5 days before and this was the first time he had operated from the field. He reported that, after takeoff, there was “inadequate thrust” to climb, and he performed a forced landing to a pasture, during which the airplane sustained substantial damage. Postaccident examination of the airplane revealed that the wing flaps were in the retracted position. Examination of the engine revealed a partial fracture just aft of the propeller flange. The fracture was visibly twisted, and the fracture face displayed a 45° angle to the longitudinal axis of the crankshaft. This was indicative of an overload type of failure consistent with the impact, and that the engine was producing power during the accident sequence. The right magneto was also damaged during the impact, which precluded functional testing. Overall, the examination of the engine did not reveal evidence of any preimpact failures or malfunctions that would have precluded normal operation. The pilot believed that the field was about 2,000 ft long; however, review of satellite images indicated that the field was only about 1,230 ft long and sloped uphill. Obstacles existed along the departure path in the form of a driveway, trees, and buildings. Review of the airplane owner’s manual indicated that, for shortest takeoff the wing flaps should be in the “full down” (30°) position. It also noted that for unusually short field takeoffs, the application of wing flaps should occur just before the airplane is ready to leave the ground, and the flaps should not be retracted until an altitude of at least 100 ft above the highest obstacle. The density altitude around the time of the accident was about 3,224 ft. Under such conditions, the pilot would have experienced a takeoff distance about 34% longer than normal and an approximate 26% reduction in rate of climb. Review of performance information contained in the airplane owner’s manual revealed that, under similar atmospheric conditions, at maximum gross weight with the flaps retracted, the airplane would have required a takeoff ground roll distance of about 880 ft; however, this information was valid for a level, hard-surfaced runway. The distance to clear a 50-ft obstacle was about 2,200 ft. No performance information was published for operations off turf/grass surfaces, which provide more rolling resistance (drag) than paved surfaces. Based on the available information, it is likely that the airplane’s takeoff and climb performance was reduced due to the elevated density altitude conditions and the additional drag provided by the grass. Additionally, the pilot did not use the short-field takeoff technique prescribed by the owner’s manual. Had the pilot more thoroughly familiarized himself with the constraints of the area he was attempting to take off from, as well as the information provided in the owner’s manual, he likely would have realized that departing from the field under the accident circumstances provided little margin for a successful takeoff and climbout.

Quoted verbatim from the NTSB record.

Other Cessna 170 accidents

Date Aircraft Location Operator Outcome Died
16 Feb 2020 Cessna 170
N170RH
Valley Center, Kansas, United States - Minor injuries -
3 Sep 2020 Cessna 170
N170JS
Morrisville, Vermont, United States - Serious injuries -
27 Feb 2020 Cessna 170
N5478C
Baker City, Oregon, United States - No injuries -
13 Sep 2020 Cessna 170
N3068A
Kiana, Alaska, United States - No injuries -
1 Jan 2020 Cessna 170
N4667C
Fairbanks, Alaska, United States - No injuries -
20 Jul 2020 Cessna 170B
N8193A
Bloomington, Indiana, United States - No injuries -

All 1,985 records for this type

Other accidents in this area

Date Aircraft Location Operator Outcome Died
24 Aug 2020 Beechcraft 55
N8629M
Nashville, Tennessee, United States - No injuries -
15 May 2020 Ercoupe 415
N3956H
Rogersville, Tennessee, United States - Fatal 1
15 Feb 2020 Rockwell 112
N377SB
Knoxville, Tennessee, United States - Minor injuries -
11 Aug 2020 Rotorsport Uk MTOSPORT 2017
N615MW
Springfield, Tennessee, United States - No injuries -
11 May 2020 Piper PA22
N4454A
Fayetteville, Tennessee, United States - No injuries -
8 Sep 2020 Piper PA28
N4166Z
McMinnville, Tennessee, United States Lebanon Flying Club Fatal 3

All 170,864 records in United States