Cessna 305 N65070

Summary

On 22 February 2020 at about 19:20 local time, a Cessna 305 registered N65070 was involved in an accident near Mokuleia, Hawaii, United States. 2 people were on board and 2 died. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

22 February 2020 at 19:20

Classification

Accident

Location

Mokuleia, Hawaii, United States

Nearest airport

Dillingham Airfield (PHDH)

Coordinates

21.5769, -158.2006

Aircraft

Cessna 305

Registration

N65070

Category

Airplane

Year built

1979

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Instructional

Phase of flight

Not recorded

Route

Mokuleia → Mokuleia

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ANC20FA024

2 people died.

A separation of the left rudder cable due to inadequate maintenance, which resulted in an in-flight loss of control and impact with terrain.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The flight instructor was providing familiarization training to the airline transport pilot in the tailwheel-equipped airplane. Witnesses saw the airplane land hard; the pilots shut down the engine on the runway, the instructor got out and inspected the airplane, then boarded the airplane again and the pilots subsequently departed. The witnesses stated that, upon becoming airborne, the airplane entered a significant right yaw over the runway. The airplane continued to the right and subsequently impacted terrain about 1,000 ft from the runway. Examination of the engine revealed no anomalies that would have precluded normal operation. Examination of the airframe revealed that the left rudder cable was separated at the rudder pulley area behind the rear seat floor and displayed a combination of severely frayed and fractured strands with tension overload signatures. There was evidence of cable abrasions and rubbing in the area of the pulley bracket. A detailed examination of the cable fractures revealed that only 16 of the 133 total wires that comprised the cable were intact before they failed in overload, resulting in cable separation. The remainder of the cable strand wires were either degraded, shortened, or bent, indicative of abnormal cable contact and abrasion. Although the aileron and elevator control cables were continuous or displayed indications of overload separation due to impact, all of the cables exhibited areas of fraying and extensive wear. The most recent documented maintenance was a 100-hour inspection completed 5 months before the accident. The mechanic who had been responsible for maintaining the airplane for the previous 2 years stated that he cleaned, inspected, and lubricated the flight control cables during the inspection; however, the debris in the under-floor compartment, excessive black grease deposits, significant wear and fractured wires of each control cable were indicative of wear that had occurred over a period of time that should have been observed and rectified during previous inspections. Based on witness statements and examination of the wreckage, the pilots experienced a loss of yaw control after takeoff due to an overload separation of the left rudder cable and were unable to regain adequate control to land safely. Although when the separation occurred could not be determined, it is possible that the hard landing just before the accident takeoff may have caused the already degraded rudder cable to be displaced and encounter excessive stress loads in the pulley area.

Quoted verbatim from the NTSB record.