Cessna 414 N46TA

Summary

On 2 May 2022 at about 19:50 local time, a Cessna 414 registered N46TA, operated by Air Travel Management LLC., was involved in an accident near Connellsville, Pennsylvania, United States. 2 people were on board and one was seriously injured, one had minor injuries. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

2 May 2022 at 19:50

Classification

Accident

Location

Connellsville, Pennsylvania, United States

Nearest airport

Joseph A Hardy Connellsville A (VVS)

Coordinates

39.9561, -79.6638

Aircraft

Cessna 414

Registration

N46TA

Category

Airplane

Year built

1972

Engines

2

Operator

Air Travel Management LLC.

Operating rule

Part 91: General Aviation

Purpose of flight

Flight Test

Phase of flight

Not recorded

Route

Connellsville → Unknown

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA22LA215

1 person was seriously injured.

The pilot/mechanic’s failure to properly secure two airplane avionics units, which resulted in the trays supporting the units to sag downward and become lodged in the movement area of the elevator bellcrank during the accident takeoff.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot, who was also a mechanic, had been troubleshooting an autopilot issue before the accident flight. He had removed and reinstalled the autopilot mode control unit in the cockpit panel and planned to complete a local maintenance test flight. The pilot initiated the flight, completed a normal run-up, and reported that nothing was abnormal with the flight controls. During takeoff and after reaching the airplane’s rotation speed, the pilot was unable to move the control wheel aft so that the elevator would move toward the airplane-nose-up direction. The pilot subsequently aborted the takeoff, but insufficient runway remained, and the airplane overran the runway and collided with trees. The fuselage and wings sustained substantial damage. Postaccident examination of airplane’s left-side cockpit avionics stack, which contained a GPS and radio unit, found that the avionics trays had sagged downward, resulting in the elevator bellcrank to become lodged within the lowest avionics tray. Further, the avionics trays were missing metal straps designed to secure the rear weight of the GPS and radio units to the structure of the airframe. The avionics tray and elevator bellcrank exhibited significant scraping and metal polishing, which indicated that rubbing contact between the sagging avionics tray and the elevator bellcrank had likely been occurring for some time before the accident flight. Neither the pilot nor the passenger (who was also a mechanic) reported observing any anomalies with the flight controls during the preflight run-up but did report that the airplane hit a dip in the runway as the airplane approached its the rotation speed. Thus, this movement likely moved the tray further downward and into the movement area of the elevator bellcrank. The Federal Aviation Administration had published advisory circular guidance advising mechanics to ensure that avionics units (including GPS and radio units) were properly secured with rear or side metal straps connected to a structural element on the aircraft. Review of maintenance records found no recent references to work involving the affected avionics or the securing of their avionics trays. The pilot had maintained the airplane for several years and signed off multiple annual inspections. During a postaccident interview, the pilot explained that he was not aware of the need to secure metal side or rear straps on avionics trays. Thus, because the pilot did not realize the need to properly secure the avionics trays to structural airplane elements, the trays eventually contacted the elevator bellcrank and precluded normal operation of the airplane’s pitch controls.

Quoted verbatim from the NTSB record.