Downer BELLANCA 14-19-2 N7658B

Summary

On 26 March 2022 at about 14:50 local time, a Downer BELLANCA 14-19-2 registered N7658B was involved in an accident near Prosser, Washington, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

26 March 2022 at 14:50

Classification

Accident

Location

Prosser, Washington, United States

Coordinates

46.0900, -119.4289

Aircraft

Downer BELLANCA 14-19-2

Registration

N7658B

Category

Airplane

Year built

1957

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Pasco → Unknown

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

WPR22LA136

Nobody was injured.

An inadequately welded elevator attachment lug, which caused the elevator to partially detach from its bellcrank, resulting in flutter and structural damage.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

During cruise flight the airplane lost pitch authority after a flutter event partially disabled its elevator and resulted in structural damage to the horizontal and both outboard vertical stabilizers. Although the airplane had limited pitch authority following the event, the pilot was able to successfully land the airplane in a field. The airplane was the subject of an airworthiness directive (AD) concerning play in the pitch trim system, which required inspection of the pitch trim tab for play at 100-hour intervals. The play in the pitch trim system had the potential to cause such a flutter event if not complied with. However, the airplane had just come out of its annual inspection and the pilot also examined the airplane in accordance with the AD just before flight. Additionally, no evidence of such play was observed during a postaccident examination. The pitch trim system had failed, but it appeared to be because of overload damage, likely sustained from the high oscillatory forces induced during the flutter event. Examination of the elevator revealed that the upper lug that connected the elevator pitch control tube to the elevator bellcrank had failed. The weld joints in that area exhibited a lack of fusion and penetration, creating gaps between the filler with the control arm surfaces and the lug. These gaps allowed fatigue cracks to initiate and propagate. Once the cracks had grown large enough, the remaining intact weld material fractured from overstress, leading to the separation of the lug from the control tube. The lug failure resulted in a partial disconnection of the control surface, which likely started the flutter event. This ultimately led to the failure of the pitch trim control arm, which would have exacerbated the flutter. Corrosion and primer identified at the lug fracture area indicated the surfaces had not been properly prepared before welding. Although the lower lug had not failed, it also exhibited similar evidence of gaps caused by a lack of fusion and penetration. It could not be determined if the lugs were welded at the time of the airplane’s manufacturer, more than 66 years before the accident, or during a subsequent repair.

Quoted verbatim from the NTSB record.