Socata TB21 N718TB

Summary

On 17 July 2022 at about 01:17 local time, a Socata TB21 registered N718TB was involved in an accident near San Marcos, California, United States. 4 people were on board. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

17 July 2022 at 01:17

Classification

Accident

Location

San Marcos, California, United States

Coordinates

33.1099, -117.2254

Aircraft

Socata TB21

Registration

N718TB

Category

Airplane

Year built

2002

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

San Diego → Fullerton

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

WPR22LA259

Injuries not recorded.

The failure of the mechanical fuel pump due to internal friction for reasons that could not be determined based on available evidence, which resulted in a total loss of engine power.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

According to the pilot, he had just picked up the airplane after an annual inspection. He conducted a pattern-only flight before departing for a cross-country flight to reposition the airplane. About 30 minutes after takeoff, there was a total loss of engine power and the pilot performed a forced landing on a road. The airplane struck a vehicle during landing, which separated the left wing from the fuselage. Postaccident examination of the engine revealed the mechanical fuel pump shaft had sheared. Further disassembly revealed rotational scoring, heat discoloration, and foreign (aluminum) debris on the pump’s rotor shaft and bearing bore. The scoring and heat discoloration were determined to have occurred due to friction occurring between the rotor shaft and bearing bore. Mechanical damage to the affected components did not allow for the determination of pre-event component measurements, including the rotor shaft or the bearing dimensions. The mechanical fuel pump was a recently rebuilt unit and was installed on the engine during the annual inspection that was completed five days before the accident. The overhaul procedures for the fuel pump specify the bearing to be honed and the rotor to be lubricated during reassembly. Honing to incorrect dimensions or improper lubrication would likely result in increased friction between the two components. Debris between the rotor and bearing could also increase friction. The rubber seal installed at the driven end of the rotor exhibited softening and deformation consistent with thermal distress, which could have allowed debris to enter the fuel pump after the pump began to overheat. Additionally, debris could have been introduced during the rebuild process or during the installation process through the fuel line ports and fittings, but due to the friction damage the source of the debris could not be identified. The fuel pump shaft sheared due to the friction between the rotor shaft and bearing bore; however, damage prevented determination of the source of the friction.

Quoted verbatim from the NTSB record.